Driver sd needs updating eth

Continue to hold-down the button until the front-panel LEDs blink and remain solid.When in safe-mode, the USRP-N device will always have the IP address 192.168.10.2.

For example, if your network interface is set to 192.168.20.1, and the USRP device is 192.168.10.2 (note the difference in the third numbers of the IP addresses), you will likely see a 'no control response' error message.

The USRP-N Series can be reprogrammed over the network to update or change the firmware and FPGA images.

When updating images, always burn both the FPGA and firmware images before power cycling.

The default IP address of the USRP2 is 192.168.10.2.

You will need to configure the host's Ethernet interface with a static IP address to enable communication.

Search for driver sd needs updating eth:

driver sd needs updating eth-50driver sd needs updating eth-63driver sd needs updating eth-8driver sd needs updating eth-85

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “driver sd needs updating eth”